Results 1 to 10 of 109
Threaded View
-
03-22-2015, 08:41 PM #10
There are a couple of options. But typically, in most cases, people connect the switch for the Z_Probe to where the Z-Endstop used to be. If you do this, the Z-Endstop can just be left where ever it is on the printer just in case you want to back up to the way it used to be. The firmware will use the Servo to engage the Z_Probe and use the switch mounted on the probe leg instead of using the Z-Endstop.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help