Results 1 to 3 of 3
Thread: i3V 10" Print Problems
-
03-21-2015, 10:25 PM #1
- Join Date
- Mar 2015
- Posts
- 2
i3V 10" Print Problems
I've been trying to print a case for a raspberry pi setup and anything I try to print that is tall seems to lose definition and get "stringy" on the final layers of the print. I'm printing with PLA and using SLiC3R. Tried changing temps, but nothing seems to matter.
I'm new to 3D printing, so I hope I can find a few tips and suggestions here on how to fix the issue.
Thanks in advance!
-
03-21-2015, 10:39 PM #2
- Join Date
- Jul 2014
- Posts
- 305
Do you have any pictures?
-
03-21-2015, 10:58 PM #3
- Join Date
- Mar 2015
- Posts
- 2
I was frustrated and tossed the last 3 attempts in the trash. Trying a new print right now so I will take pictures once that is done. The best way I can describe it is in printing tall objects (3-4" tall), the final 1/4" the layers are NOT sticking together, so it's very stringy. Ruins what is otherwise a good print.
Last edited by jsg22; 03-22-2015 at 12:04 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help