Results 1 to 4 of 4
Thread: Prints sloping off
-
03-21-2015, 02:31 AM #1
- Join Date
- Mar 2015
- Posts
- 8
Prints sloping off
Hi all, new to 3D printing. I have a new CTC printer that worked fine for a week then I desided to upgrade the F/M to sailfish v 7.7. This was not done by myself. I had a guy do it for me.
Having a couple of problems
1 Printer now seems to print at a speed which makes it jump allover my desk (rubber feet fitted)
2 Prints are sloping off to 1 side (to the rear)
The guy that upgraded it dident make a note off the home off sets but I don't think this is anything to do with the problems im having.
Would appreciate any help you can offer.
-
03-21-2015, 12:03 PM #2
- Join Date
- Mar 2015
- Posts
- 8
Sorted it.
-
03-21-2015, 12:55 PM #3
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
So to help the next guys that have the same problem you sorted it by:
.................................................. .......
Fill in as appropriate.
-
03-21-2015, 01:03 PM #4
- Join Date
- Mar 2015
- Posts
- 8
Manual for sailfish says Acceleration is on by default.
Was not the case so I just turned it on and all is fine now
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion