Results 1 to 4 of 4
Thread: abl and then nothing
-
03-20-2015, 11:17 AM #1
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
abl and then nothing
im running into a weird issue,
i start a print job, it homes and then runs the abl sequence fine but then right when its about to start printing,, it stops, nothing happens, just frozen,,
and i have to cancel the job
its almost like it hits a endstop but its not
running latest marlin with simplify3d
-
03-20-2015, 12:10 PM #2
- Join Date
- Feb 2015
- Posts
- 211
-
03-20-2015, 02:37 PM #3
That is exactly what my printer does if I don't specify that it should do a lot of Auto Bed Leveling points. The reason is the generated GCode from Slic3r will tell it to wait until the nozzle is up at temperature. Is it possible you have a broken thermistor or wiring for the nozzle? Can you heat the nozzle up from PronterFace without actually starting a print?
-
03-22-2015, 10:30 AM #4
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
im using simplify3d but yes i can heat it up just fine
I reverted back to old version of marlin and its fine
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion