Results 1 to 5 of 5
Thread: how to print 1mm solid walls?
Threaded View
-
03-09-2015, 12:18 PM #5
I revisited Roberto's suggestion and ended up with some very solid prints. The outer surface is a little rough but the wall widths came out nice and consistent. In almost a year I have only had one print failure due to a clog. This weekend I had 6 failures 4 of them were spool issues and two were power failures from the snow storm. Turns out at least 2 were due to a bit of plastic flashing on the inside of the spool that was catching the filament. I was afraid it was my altered profile but the last three prints are near perfect.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion