Results 1 to 7 of 7
Threaded View
-
03-05-2015, 11:58 PM #7
- Join Date
- Mar 2015
- Location
- California
- Posts
- 28
My understanding is that you are indeed correct about the Dremel. I love my Flashforge Creator Pro. I've seen a good amount of prints and, in my opinion, the Flashforge prints better than most. This Octopus SD card holder was printed at .1 using eSun red ABS. The surface wasn't touched up at all, that's straight off the printer. I did clean a few stringy bits out of the SD card holder slots though.
Check out my vid of the unboxing of this bad boy here... http://makersome.com/flashforge-creator-x-pro-unboxing/
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion