Results 1 to 10 of 321
Thread: Flashforge 3D Creator forum.
Threaded View
-
03-01-2015, 11:06 AM #11
My Creator Pro came with Kapton tape pre-applied... and also with 2 blue pre-cut, thick plastic sheets similar to BuildTak surface. I am using these sheets and they seem to react pretty good. I had a print that was stuck. I heated the platform again, the support became flexible and it was much easier to remove.
Printare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion