Results 1 to 8 of 8
Thread: Possible Causes for This?
Threaded View
-
02-25-2015, 03:13 PM #5
- Join Date
- Feb 2015
- Posts
- 8
Im using replicatorg. When I run gcode a window pops up with a couple values to edit. I input feed rate and travel rate as well as nozzle temp. I always run my PLA at 200C. Then I convert the gcode to xg3. I slap the file on an SD card and print from there. HOWEVER! no matter if I print from SD or from reolicatorg via computer my input nozzle temps get over ridden and goes back up to 230C.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help