Results 1 to 4 of 4
Thread: RAMBO Motor Current Settings
-
02-24-2015, 09:52 PM #1
- Join Date
- Nov 2014
- Posts
- 58
RAMBO Motor Current Settings
hi guys . i have been trying to reduce the motor noise and vibration as low as i can without skiping steps but i have noticed that going lower than the default "100" on the Digipots value that the stock firmware have as a default my motor hiss on idle and humsss when printing .
have anyone found the "sweet Spot" for this motor to run? at what values you found they work better?
Also does the Rambo board manage the current for both Z motors? or the current actually be splited . for example 185 = 1 A if i put this value on the Z axis . the board sends 1 A to each motor or 0.5 A ? looking at the board theres only 5 Drivers so im guessing that both motors are actually driven by the same driver .
-
02-24-2015, 10:04 PM #2
- Join Date
- Nov 2014
- Posts
- 522
i dont know that anyone has figured this out honestly
-
02-24-2015, 11:03 PM #3
- Join Date
- Nov 2014
- Posts
- 61
Ive left all mine at 100 and have not noticed anything wrong with it. The only motor that gets hot is my extruder motor but its nothing crazy.
-
02-24-2015, 11:10 PM #4
- Join Date
- Nov 2014
- Posts
- 522
Yeah thats why ive left mine as well... My extruder gets hot but not. burn you hot so i left it alone
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion