Results 1 to 10 of 166
Thread: New 12" user and I am LOST!
Threaded View
-
02-24-2015, 02:48 PM #28
- Join Date
- Nov 2014
- Posts
- 58
I suggest that you check the following things to see if it improves your prints.
1) reduce the infill perimeter overlap a bit.
2) make a thin wall calibration assuming you did your e-steps already fine tune your extrusion adjusting the extrution multiplier.
3) maker sure your filament is rolling smoothly. ( the provided stock spool holder is awful).
4) try to level you bed as good as you can even though you have abl. You can use G29 n3 T V4 to see your bed topography if you are using the enhanced version.
Also I noticed that your corners are curling up its seams that you are probably a extruding a bit to hot. In my case I have noticed that I need to lower the temp a bit for black abs. (235c)
You are in the right direction at this point little changes will get you there.
I have 2 month with My printer and I'm still playing with the settings. .... I'm still not satisfied with the quality.Last edited by pichuete; 02-24-2015 at 02:54 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help