Results 1 to 10 of 156
Thread: Rumba and Auto-Bed level
Threaded View
-
02-19-2015, 09:31 PM #11
- Join Date
- Feb 2015
- Posts
- 371
So the code should look something like this...
//Added to pins.h to control the extra servo at section "Motherboard is 80" (RUMBA).
#ifdef NUM_SERVOS
#define SERVO0_PIN 5 // For RUMBA PWM_1 is to be used for the servo it is on Epansion slot 3, pin 5
#define Z_MIN_PIN 33 //For RUMBA pin 33 is used for Z min.
#endif[/i]
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion