Unless I am mistaken this is the home feedrates from the config file.

#define HOMING_FEEDRATE {50*60, 50*60, 4*60, 0}

that is the X, Y, Z, extruder rates, in that order.

There are at least a few threads on the reprap.org forums about this.

Quote Originally Posted by printbus View Post
Who says that? On these printers? I don't recall this ever being discussed in this subforum, except for my INCREASING the homing feedrates. I can't speak to what MakerFarm is providing for firmware these days, but the standard configuration.h file at least used to specify a Z homing feedrate of 50mm/min. That's less than 1mm/sec. So, I'm not sure what the 4 or 3 is referring to.