Results 1 to 2 of 2
Thread: Filament Stuck
-
02-16-2015, 01:21 PM #1
Filament Stuck
All,
I have been having some problems with a specific spool of material, eSun PETG. Each time I print with it, at some point during the print, the filament ceases feeding and winds up spewing out of the extruder.
I expect this is due to variations in the diameter of the filament in addition to the "slimness" of the Hexagon feeding tube, would that be a correct assessment of what is going on?
-
02-16-2015, 01:38 PM #2
- Join Date
- Dec 2014
- Posts
- 28
That same thing was happening to me with Proto-pasta PC-ABS. My problem was solved with a combination of raising the temp of the hot end/lowering the print speed.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion