Results 1 to 5 of 5
-
02-15-2015, 08:38 PM #1
- Join Date
- Feb 2015
- Posts
- 4
CTC 3D Dual Extruder and Simplify3d Software
My 3d printer prints fine using Makerbot. whenever i try to print using simplify3d, the ABS filament comes out slow and begins to clog up. Anyone using Simplify3d with a CTC3d printer? I think my FFF settings need to be tweaked but not sure what to do.
-
02-16-2015, 03:17 AM #2
I'm using Simplify3D too. I tweaked the values by experimentation. What I suggest is you go to your process page and put here screens of all the tabs and we can discuss that.
-
02-16-2015, 07:00 AM #3
- Join Date
- Feb 2015
- Posts
- 4
Here are the remaining settings.
-
02-16-2015, 08:08 AM #4
- Join Date
- Feb 2015
- Posts
- 4
I had to delete my original post because i couldnt edit it. "The message you have entered is too short. Please lengthen your message to at least 10 characters."
-
02-16-2015, 04:34 PM #5
Please :
1/ try to enlarge a bit
2/ I think the most important would be to display your extruder temp tab as well as be temp tab and finally the tab with all the speeds.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion