Results 1 to 10 of 16
Threaded View
-
02-15-2015, 01:36 AM #16
- Join Date
- Feb 2015
- Posts
- 211
Well just an update here. I re-calibrated my Esteps again. It wasn't too far off. Even after re-calibrating S3D was still under extruding, I printed several calibration items and ended up having to bump up the extrusion multiplier by 10% to make it extrude correctly.
I can tell you that I am pretty disappointed with the lack of support from S3D, I sent an email regarding the extrusion issues that I was having asking them for some help getting it setup correctly for my printer. I never heard a word from them. That is pretty sad considering that I spent ~$150 on their software. You would think for that much $$ they would have phone support or at the least answer their email.
Not sure that I would buy any software from them in the future.
Thanks,
Chadd
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help