Results 1 to 5 of 5
Thread: The Creepy Carriage
Threaded View
-
02-11-2015, 07:55 AM #3
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
You can use the bubble level to level the surface the printer is sitting on. but I would level the X to the Y using some block.. like some lego as it has consistent height
using a bubble level will level it to the earth, not to itself
once that is done then level the bed using the nozzle gap
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion