Results 1 to 5 of 5
Thread: Windows 7 64bit Driver
-
02-11-2015, 06:53 AM #1
- Join Date
- Feb 2015
- Location
- Netherlands
- Posts
- 15
Windows 7 64bit Driver
Hi all,
I have a Flashforge dreamer and Windows 7 64bit does not recognize the printer.I installed Flashprint and the driver should be installed automaticly.It installed the driver but still it is not installed properly.In device manager I can see the printer icon with a yellow exclamation mark.
So the printer driver is not installed properly.Also I tried several different usb ports with no result.What can I do?
Menno
-
02-11-2015, 08:30 AM #2
- Join Date
- Oct 2014
- Posts
- 314
Did you run the installation as a local admin? W7 gets bitchy about that sometimes.
-
02-11-2015, 08:32 AM #3
- Join Date
- Feb 2015
- Location
- Netherlands
- Posts
- 15
No I did not.I will try this this evening.Thank you!
-
02-11-2015, 01:32 PM #4
- Join Date
- Feb 2015
- Location
- Netherlands
- Posts
- 15
I try to install under local admin with no succes.So no driver properly installed.Every time when i want to do something under the tab Tools the programm crashes.What is wrong here?Is this programm working with 64bit?
-
02-16-2015, 03:52 AM #5
- Join Date
- Feb 2015
- Location
- Netherlands
- Posts
- 15
Flashprint V1.3 is not working with Firmware V2.2
Firmware V2.2 is not working with Flashprint V1.3
Look in your printer what Firmware is installed.If it is V1.3 than use Flashprint V1.3
Then flash Firmware V2.2.Remove Flashprint V1.3 from your computer.Install Flashprint V2.2 on your computer.That was working for me.
Menno
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help