Results 1 to 10 of 10
Threaded View
-
02-09-2015, 04:21 PM #4
- Join Date
- Dec 2013
- Location
- Georgia
- Posts
- 934
1-2 years? I'd say less than a year. The LumiFold is less than $600, combine that with a $300 projector and you're still under that price point. There is also the iBox Nano at $300 (with a tiny build volume) and the Peachy Printer at $99 (if you're up for an assembly and calibration challenge) which both might be out later this year. (the Peachy will probably be out before the iBox.)
A better way to do the conversion is that 1 liter of fresh water is 1 kg...
The cheapest I've ever found is $55 per liter, so roughly $50 per kilogram (resin is a little bit denser than fresh water).
More expensive than cheap filament, but certainly not as bad as the brand-name stuff.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion