I have got about 75% of the parts printed now and an Arduino all set up.

The first thing i have discovered is that the size of the stepper motor was not listed so the one i have which is a kysan is about 7 mm to big for the motor holder. So i may have to print a small bed for the holder and camera mount to sit on to extend it by 10 mm so there is a bit of a gap underneath.

Next is to make the shield for the Arduino.

Quick question for Jesus89 . Are there any plans for posting the PCB layouts to something like oshpark.com. I am trying to figure out if i can just zip the Gerber files up and send to them.

Thanks

Davey