Results 1 to 10 of 11
Thread: Beginner questions
Threaded View
-
02-06-2015, 11:59 AM #6
- Join Date
- Feb 2015
- Posts
- 17
Yes, I have the acrylic pieces over the top. But, of course, there's a big hole where the wires go in, and slits in both side walls of the enclosure. I did a bit of poking around with an IR thermometer. With the platform set to 115, sides of the piece being printed are somewhere around 80-85, the extruder seat (black plastic piece) measures at 60. I'll try to block the slits in side walls and see what happens.
I've been printing at default speeds (40/55).
Are you suggesting that I should get a micrometer and measure the actual diameter of every roll?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion