Results 11 to 13 of 13
Thread: Occasional Click Printing PLA?
-
02-01-2015, 11:53 AM #11
video sounds okay. You might want to lube the rods though.
Couldn't hear any clicks.
-
02-02-2015, 06:35 AM #12
- Join Date
- Jan 2015
- Posts
- 47
Thank you. I actually just ordered the grease off of amazon.
-
02-04-2015, 01:01 PM #13
- Join Date
- Feb 2015
- Posts
- 13
I recognize that sound. Not sure what your entire feed system looks like, but usually the filament bends around a little between the roll and the hotend. That causes the occasional clicking or rustling sound. It's happened a couple times as I sit here writing and this helmet I'm printing still looks pristine.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion