Results 1 to 3 of 3
Threaded View
-
02-02-2015, 11:26 PM #3
- Join Date
- Jan 2015
- Posts
- 10
Thanks. I dialed back almost all of the feedrate and acceleration parameters. It works just fine now. I was able to perform a dry run (still no extruder) and it prints just fine. I think it took 11 minutes for the printer to (think) it print the small wade gear. Have I dialed back too far, or is this pretty "normal" using 30% infil?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help