Results 1 to 10 of 12
Threaded View
-
02-01-2015, 12:11 PM #1
Anyone had issues with ABL where one Z axis side moves more over time then the other
Last night I had a few prints go wonky right after that start. As I started looking at the printer I noticed that my X carriage was no longer level. Releveling the X carriage fixed the printing issues.
I have seen this before, but i was usually due to manually messing with the Z screws or one side getting bound up for some reason. While watching the print this morning the Z screws seem to be moving in sync but did not know if some of the excess Z movement due to ABL could be exacerbating some other underlying issue.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion