Results 1 to 1 of 1
Thread: Rough top line
-
01-31-2015, 11:32 AM #1
- Join Date
- Jan 2015
- Posts
- 47
Rough top line
I just switched to slicer 3d and on the top few layers I'm not seeing an even deposit. It was at the top speed, and I'm printing it at a lower speed right now, but I'm hoping there's some other settings I could adjust instead. Anybody have any ideas?
Resin has changed after...
06-18-2024, 10:34 AM in General 3D Printing Discussion