Results 1 to 4 of 4
-
01-27-2015, 01:13 PM #1
- Join Date
- Jan 2015
- Posts
- 4
How to fix lifting bottom, warping and curling
So I have the replicator 2x, and my problem is that, every time I try to print something like a pen/pencil holder, it keeps lifting, despite the tempurature staying constant at 110 degrees.
So how do I fix this?
Thanks!
-
01-28-2015, 12:51 AM #2
- Join Date
- Jan 2015
- Location
- Austria
- Posts
- 19
I had the same problems when I tried to print small things
first thing I changed was printing them with rafts and then I also increased the bed heat to 120
-
01-28-2015, 10:11 AM #3
- Join Date
- Jan 2015
- Posts
- 4
Right I had rafts on too but i literally had create a square raft just so that the corners wouldn't lift, but it keeps lifting
-
02-07-2015, 08:06 AM #4
- Join Date
- Dec 2014
- Posts
- 8
I have a Z18 so there is no heated bed but I did encounter lifting issues. My solution was a light coating of hairspray and done. now there is no lift at all and sometimes it tough to get the print off of the build plate. Luckily the built plate is removable though. Give that a try and let us know if it helps.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion