Results 1 to 5 of 5
Threaded View
-
01-27-2015, 02:51 PM #4
- Join Date
- Dec 2014
- Posts
- 16
Glad it works for you. These types of problems can be a pain to track down. If you added the fix for the Y moving your Z offset might not be 9.7 anymore. If your nozzle is too high to print, check the offset again. The code change will remove the 4mm error so -5.7mm would be the offset I expect for you. It fixes both the Y Moving and the incorrect height after G28. If you always do a G28 then G29 you would not see the problem. I do a G28 only a lot of times, I use the G29 more to measure the bed than to correct it.
Last edited by mwyrick; 01-27-2015 at 02:58 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help