Results 1 to 10 of 19
Threaded View
-
01-26-2015, 12:25 AM #9
- Join Date
- Jan 2015
- Posts
- 9
I'll try make a video tomorrow, but the bed's been re-leveled. I've discovered my print bed is not level in the process, but I can deal with that another time. As long as I print near the center, it's level.
Extrusion rate seems perfectly calibrated to the best of my detection abilities.
Now the problem seems to be narrowed down (as i see it) to when it's filling in a layer. Perimeters are coming out fine while it traces lines around the edge, but when it fills in the area between perimeters it's too thin. So now I'm getting objects with a fine horizontal shell but with non-solid top layers.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help