Results 1 to 10 of 33
Thread: Desperate for bed adhesion !!!!
Threaded View
-
01-19-2015, 02:48 PM #10
I hope it works.
Another option is to print the first few layers with the bed at 110C, then reduce the bed temp to 80-90C, so that there's not so much difference between the temperatures of the layers. I really think temperature difference is the cause of your issue. I print ABS with the bed at 70C the whole time - but with hair spray.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion