Close



Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11
  1. #11
    Student
    Join Date
    Dec 2014
    Location
    Iowa
    Posts
    25
    Add roybfr on Thingiverse
    So updated to dacb's fork of Marlin with ABL this weekend. So far things are good but I have one new issue on overhangs that so far I can get to go away.



    Printed this low poly squirtle in ABS. Notice I am getting a few hanging extrusions. Should I slow my outer later down?
    Attached Images Attached Images

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •