Results 1 to 9 of 9
Thread: Removing ABS Slurry
Threaded View
-
01-15-2015, 05:17 PM #9
I got some clear from Monoprice that is running well. I've had good luck with stuff from Microcenter also. Clear ABS isn't 100% clear, more like translucent.
There is no way around a flat glossy bottom of your print when using glass no matter what you use. That slurry layer is fused solid or should be. That said, I have mainly been using glue stick, but even then the bottom is a different texture than the rest of the build up layers. This is because of how the first layer gets smashed into the bottom surface.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion