Results 1 to 9 of 9
Thread: Power Supply for i3v 12 Kit
Threaded View
-
01-03-2015, 04:23 PM #2
If 13.6V DC doesn't fry your 12V DC radio gear, then the printer should handle it. BUT!!! Ask Colin first. He's only an email away.
I might be wrong, but I seem to remember that the 12V supply is used mostly for the heated bed, and that supply now runs through a relay, so it doesn't actually touch the board. I don't know the construction of the board, but most have a little circuit that drops 12V to 5V, which is the usual operating voltage for things electronic. That circuit should handle 13.6V. But again, Ask Colin.
Read what Printbus said about power supply here: http://3dprintboard.com/showthread.p...ooby-questions
Old Man EmuLast edited by old man emu; 01-03-2015 at 04:28 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help