OK. Here is my largest print ever.
Couple of issues...
Raft problem: Same as before, but I have not tried the new setting yet.
Raft Warp: The upper right hand corner cam up a couple mm. While not catastrophic, not yet perfect.
Filament not sticking: The right side X section looks like the filament did not stick and was dragged out into the open space. Is this a temperature issue? Too hot or cold?
Other than those, a pretty good 28 hr print.
2014-12-31 14.44.17.jpg2014-12-31 14.37.38.jpg
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion