Results 1 to 8 of 8
Hybrid View
-
12-30-2014, 05:27 PM #1
You should definitely tweak your settings, all of them. Just don't expect the ones that ship with your printer to be perfect. There are subtle variations in hardware and one calibration will not suit all printers, even the same brand and configuration.
As for the blobs, try reducing the print temp. I print ABS on my Makerfarm at 225C routinely and get pretty clean print sides. It took me weeks to get settings that were good. Tweak, print, tweak, print, tweak, print, success.... See the pattern? Keep good notes and it will make your life better. I mark prints with a sharpie and save the configuration settings in separate files named the same way until I get it tuned in. Then I compare and know what I'm looking at.
Keep tweaking, you'll get it...
Check out this thread: http://3dprintboard.com/showthread.p...-reduce-oozingLast edited by RobH2; 12-30-2014 at 05:34 PM.
Bambu P1S/AMS
NVision4D http://nvision4d.com
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help