Results 1 to 1 of 1
-
12-29-2014, 06:21 PM #1
New hardware available (filament producer) Protocycler
Sorry if this has already been posted.
There is a company called Rede (ready) Tec that is offering a recycler extruder. Your failed prints can be chewed up in a onboard shredder then merely dumped into a hopper where they will be extruded into filament and spooled up while you wait. They predict that it will spool filament at 10 feet per minute. Here is a vid on youtube of their device.
This is their website
http://www.redetec.com/
Or if you prefer you can find them on Facebook.
https://www.facebook.com/redetec3D?fref=nf
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion