Results 1 to 5 of 5
Thread: IcePick Delta 3D Printer
-
12-19-2014, 01:21 PM #1
IcePick Delta 3D Printer
Hackaday user TTN and Matt Kimbal have been working on development of the IcePick Delta. The IcePick Delta is a 3D printer designed without linear rods or bearings. The final outcome of the 3D printer, nearing completion, will be a streamlined machine that is simple and affordable, with easy maintenance due to the design which features less parts than usual. Check out more details about the project: http://3dprint.com/32039/icepick-delta-3d-printer/
Below is a photo of the IcePick Delta:
-
12-22-2014, 08:28 PM #2
Awsome!
I have been following the firepick delta for a while, and i was bummed that it didn't make the finalist in the hackaday prize, this is an intresting update.
-
12-28-2014, 02:22 PM #3
- Join Date
- Dec 2014
- Posts
- 1
Help with sofware
I have been also developing printer inspired by Firepick but with uv laser and resin. What I can't find with what software to run this printer. Tried ReplicatorG, Slic3r, Cuda, CW no success with any of those probably i can't configure them properly. I have RAMPS 1.4, Icepick Marlin firmware from Github (btw delta example configurations, when trying to upload, throw errors).
Any suggestions how and which software to configure?
-
12-28-2014, 03:08 PM #4
Bonapartista,
Post an enquiry about your software difficulties here: http://3dprintboard.com/forumdisplay...ents-to-Marlin
The Marlin gurus might have an answer for you if you tell them what errors are coming up.
Old Man Emu
-
12-29-2014, 06:45 AM #5
that is a really ingenious design - about as close to a reprap as you can currently get.
So when they say it prints slowly - what kind of speed ar we talking about ?
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help