Results 1 to 10 of 11
Thread: Best Power Supply for a RepRap?
Threaded View
-
12-31-2013, 09:08 AM #5
Every PC power supply of about 400-500 watts will be enough,
You should pay attention if it has enough 12V cables with enough Amps on it.
I had a gigabyte superb 470w , works as it should and only was 30 euros i guess.
Only had to cut a few cables, put it in my ramps and its good to go.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion