Results 1 to 2 of 2
-
12-08-2014, 08:08 PM #1
- Join Date
- Dec 2014
- Posts
- 1
Any ideas what is causing stringyness after the print is already going?
I had a bad clog that would not clear so I replaced the 0.4mm nozzle and am still getting failed prints.
Any ideas?
Failed Print.jpg
-
12-25-2014, 01:58 PM #2
- Join Date
- Dec 2014
- Posts
- 18
Where do you get your filament from?
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)