Quote Originally Posted by Warkitteh View Post
Hello,

I'm new to 3D printing (but not to 3D modeling) and just ordered a FlashForge Creator model for much less than it would cost to buy the latest version (Creator Pro).

My questions are:

Are there upgrade options for the model that I ordered so that I can benefit from the following new features offered in the Creator Pro:
  • warp-resistant 6.3 aluminum build platform
  • heat-resistant metal platform
  • improved (10mm) z-axis guid rod


Kapton tape vs. glass - I see that kapton tape is very expensive and have read some conflicting reviews on using glass instead of kapton tape. Any advise here is appreciated.

Some advice, or a re-direct to an existing thread would be great!

Thanks,
Warkitteh



Do you need to add a geared stepper for the 10mm rod or do you think a normal one could handle it? ive done just about everything to my Flashforge (which has been a trusty if not noisy little box) but never thought about upgrading the Z rod, but it makes sense as even with the 8mm guide rods on either side, you do get a little bit of play if the rod is bent.. I can't see a 10mm threaded rod bending in a hurry.