Results 1 to 10 of 18
Threaded View
-
12-24-2014, 09:27 PM #7
tomorrow I am going to switch the ramps boards between the two machines and see if the problem moves. if it does, I'll contact Makerfarm about getting a replacement. I'll post up how that goes. Thank you.
Edit:
transplanted my ramps board and the printer ran fine. so this appears to be hardware rather than software. Thanks for looking into it.
We still have the offset issue mentioned above even with a new abl probe offset measurement.Last edited by TopJimmyCooks; 12-25-2014 at 07:46 PM.
New member with print issue
Yesterday, 08:57 AM in Tips, Tricks and Tech Help