Results 1 to 4 of 4
Thread: Y Axis Issue with Marlin
Threaded View
-
12-22-2014, 06:44 PM #2
Are the settings for this line in configuration.h set properly for your hardware? It shows Y having 1/2 the value of X. The four values are for X, Y, Z and the extruder.
#define DEFAULT_AXIS_STEPS_PER_UNIT {44.3090,22.1545,1600,53.5} // default steps per unit for Ultimaker
I'm not familiar with the printer, so I can't help with exact values. Depending on the hardware, these may be of help -
http://prusaprinters.org/calculator/
http://reprap.org/wiki/Triffid_Hunte...Guide#XY_stepsLast edited by printbus; 12-22-2014 at 06:46 PM. Reason: Fixed link to T Hunter page
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help