Results 1 to 6 of 6
-
12-21-2014, 04:46 PM #1
- Join Date
- Dec 2014
- Posts
- 3
Ordered 3D Creator Pro, but received the Dreamer model; advice?
Hi:
I ordered the 3D Creator Pro from B&H, but when I opened the package this morning, I discovered it was the Dreamer model :-( I've already requested the RMA from B&H, but I wanted to check on this forum before I return it - what are the differences between the two? Currently they both seem to be priced the same (and have the $150 rebate). Should I keep or send it for the other model (which seems to be somewhat more capable)?
Anil
PS: This is my first 3DP, FWIW.
-
12-21-2014, 04:56 PM #2
-
12-21-2014, 07:31 PM #3
- Join Date
- Dec 2014
- Posts
- 3
Thanks Geoff. I saw that, but could not decide based on it :-) Realizing that most people have not used both models, may be I can rephrase my question: have folks had any issues with the Dreamer or found it limiting in some way? I spent a decent amount of time reading about the Creator Pro before I ordered, so it's a little confusing to get the other model that I had not done any research on. I had been looking forward to setting up and playing with the printer over the holdays, so I'm trying to decide whether I should just keep it.
Anil
-
12-21-2014, 11:15 PM #4
I would get the Creator Pro. The dreamer isn't that much of a dream.
-
12-21-2014, 11:24 PM #5
- Join Date
- Dec 2014
- Posts
- 3
-
12-23-2014, 05:03 AM #6
I've had the Dreamer for a month and a half now, also my first printer. I haven't had any issues with it, like it quite a bit. There are far more challenges with my lack of 3D modeling skills than any shortcomings with the printer itself.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help