Results 1 to 10 of 26
Threaded View
-
12-30-2013, 01:24 AM #16
That would be great!
This quad arm takes me pretty much exactly 1.2 hours to print. I print them at 25 percent infill, obviously higher will yield a stronger arm but the idea is to keep it as low as possible, but without warping.
When I print them, they are dead straight, when I pull them off however, even after a full cooldown, the flat section will warp slightly. PLA didnt seem as bad, but since the ABS needs heat and I really sort of need to print them in ABS :/ PLA is no good even for small crashes with a quadcopter, ABS is alot more forgiving.
http://www.mediafire.com/download/3h...u3/quadarm.zip
The arms in question are like these:
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion