Results 1 to 10 of 13
Threaded View
-
12-18-2014, 08:46 AM #5
- Join Date
- Dec 2014
- Posts
- 40
Interesting. When you say you've seen the same thing, you mean you've been experiencing this problem too? Have you been able to generate x3g's for any stl's over a couple hundred KB? I don't think Makerware is the problem because it's happening only on the computer, the firmware doesn't seem to be a problem.
If moving to an older version isn't an option, you could try Matter Control's beta x3g support. Alternatively, there's a way to use Slic3r with Makerbot machines (full disclosure - I have only tried this with a Replicator 2X). The method is documented here - http://www.3duniverse.org/2014/01/05...forge-creator/.
Good luck!
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion