Results 1 to 10 of 74
Thread: i3v 12" build log
Threaded View
-
12-17-2014, 12:37 PM #26
- Join Date
- Nov 2014
- Posts
- 522
I skipped ahead a little to write this... Ill go back and read/edit if needed.
Google reprapelectro rambo 1.1b user manual
it has a full writeup on flashing firmware to the board. Including setting the board as rambo in the dropdown in the arduino software.
edit: http://reprapelectro.com/wp-content/...ser-Manual.pdf
supposedly if the board isnt registered as rambo in the arduino software the screen may not work. I followed the user manual just in case...
/end edit:
The board does not come with firmware preinstalled.
On my phone atm or i would just post a link.Last edited by sniffle; 12-17-2014 at 01:19 PM.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)