Results 1 to 10 of 74
Thread: i3v 12" build log
Threaded View
-
12-15-2014, 04:53 PM #11
- Join Date
- Nov 2014
- Posts
- 522
So fi ished the printer up today for the most part havent run any filament through it yet still have a little work to do.
For some reason im only getting backlight on the display. With no text even after i recompiled and uploaded the firmware and i have to figure out why the board isnt powering up without the usb connected as after calibration and config i plan to mostly use this stand alone with the sd card and abl.
As to the problem of the heat bed relay and the rambo mount. I have it to at the moment i just have the rambo mou t losely fit in place. Depending on material needed to be removed i may shave the relay pcb down instead of the rambo mount as i can shave it off faster and easier than the wood. If that would eat i to the mount holes ill just remove a combo of both to make sure there wont be any accidental shorts from the rambo board touching the relay.
Now off to buy glass and some more bolts so that i can ensure that the mount isnt the issue.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help