So build update of sorts.

I have been working on the build for the last 2 nights, after working 12's. I am down to electronics and extruder. Probably a few hours tomorrow will get it finished if i can get the kids to leave me alone :-P no pictures been too focussed on getting ti built while the kids were away and too tired to think about it after the fact :-)

I'll hopefully get it's new home cleaned up and it placed this evening with a pic or two. :-)


I will say that when putting together the large "deluxe" display that the holes really didn't line up at all, and the housing doesnt take have cutouts for the solder pins. for me at least there is slight stress on the board due to the 16mm bolts not being quite long enough as well. I think my first design improvement for the printer will be fixing that.