Results 1 to 10 of 757
Threaded View
-
12-09-2014, 05:56 PM #11
- Join Date
- Aug 2014
- Posts
- 627
>>> m114
SENDING:M114
X:192.00 Y:170.00 Z:7.82 E:0.00 Count X: 191.99 Y:169.99 Z:8.10
>>> m114
SENDING:M114
X:192.00 Y:170.00 Z:0.52 E:0.00 Count X: 192.00 Y:170.00 Z:0.80
#define Z_PROBE_OFFSET_FROM_EXTRUDER -1.85
Now shouldn't that be zero when it hits my card?
Bed Height Topography:
+0.08786 +0.07386 +0.06711 +0.10086
--0.05364 --0.01064 +0.03186 +0.11586
--0.17089 --0.07164 +0.00086 +0.12311
--0.26139 --0.13414 --0.03164 +0.13261
edit: Interesting but not by making the offset larger but by making it smaller does the gap increase. That is contrary to what I thought it should be.
So, the closer to 0 that offset is the wider the gap from the bed becomes until the gap is at its widest with the offset set at 0. Honestly this makes no sense unless there is something hidden with a static value or something.Last edited by DarkAlchemist; 12-09-2014 at 08:33 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help