Results 1 to 5 of 5
-
11-27-2014, 12:16 PM #1
Has anyone had any success printing in wood filament
I bought a roll of wood filament from colorfabb and started to print, however the nozzle keep getting blocked with the extruded wood filament. I am using 1.75mm on a solidoodle 2. I just can't seem to print a successful object. Has anyone had any experience with this new material?
Thanks
-
11-27-2014, 12:20 PM #2
- Join Date
- Aug 2014
- Location
- Montreal, Quebec
- Posts
- 576
What is the diameter of your nozzle ?
-
11-28-2014, 09:56 AM #3
We print LayWoo-D3 fine through a .5mm nozzle.
-
11-29-2014, 06:58 AM #4
printed laywood through a 0.4mm nozzle on my flashforge at 200c - no noticeable issues.
Prints nicely, doesn't warp, sticks to blue tape without glueing itself like pla can.
No actual problems. That doesn't help you I realise.
What temp were you printing at ?
-
12-01-2014, 12:34 PM #5
Printing, no problems. Storing, however, was a different issue. Stuff snaps like twigs.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion