Results 1 to 10 of 396
Threaded View
-
11-26-2014, 07:37 PM #11
- Join Date
- Aug 2014
- Posts
- 25
got this loaded up today. been using the regular zenmaster setup for ABL and so far so good printing at .3 layer height with good results. when i print at .1 layer height i get some issue see video
nozzle is pushing/dragging through the print. feed rate 20mms temp 200. using the Prometheus hot end .4 orifice. extrusion multiplier changed from 1 to .95 to .90 still had issues. not sure if it something with the auto bed leveling
thanks for any help
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion