Results 1 to 10 of 91
Threaded View
-
11-22-2014, 09:45 AM #32
Hi guys been a very busy week but now working on the printer again,
I have sorted out the switch, it was a simple connector fault, replacing fixed that.
now just the X motor just makes a juddering noise sort of like a machine gun. i've increased the voltage a tiny bit but still not working, must be something to do with the acceleration? also the extruder is doing the same. just the jittering is much slower? i need to get another feeder thingy, the one that drips onto the filament and pushes it down. will go buy that today :/ didn't last long, saying that i haven't even been able ti use the motor to drip the filament :/
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help